Description

CTEK Battery Charger Adapter for Ferrari

3 (out of 4) pin locking plug for Ferrari charging ports (normally located in footwell)

This connector will enable the ignition stop feature and dash light feature when plugged in (the vehicle will display a light on the dash when charging and will not be able to crank the engine when the charger is connected).

The lead and connector has been professionally assembled and soldered in house by our cable experts to allow for the very best charging performance. This lead enables fitment to Ferrari charging ports with all current and old CTEK chargers.

This allows the user to use any existing CTEK charger with their vehicle; rather than buy a new branded charger.

Total length is approximately 25cm.

Known Fitments:

Pre 2015:

California / 360 / 430 / 456 / 458  / 550 / 599 / 612 / F12

Warrantied against manufacturing faults only. Terms & conditions apply. In short:

What’s covered: A manufacturing fault that has caused the clip to fail. Items must be sent back (at customers cost) for inspection by us & will be replaced and sent back free of charge if found to be a valid claim.

What’s not covered: wear and tear cable breaks damage caused by misuse rust burnt corroded or used improperly

Groves Batteries is not affiliated with Bentley Rolls Royce Aston Martin or Ferrari. These adaptors are assembled in-house using existing CTEK leads and other sourced components and are not official CTEK products once assembled. We are an authorised distributor & stockist of CTEK branded goods & all CTEK goods used in assembly (i.e. cables & plugs) are genuine CTEK items.